User Manual

Disconnect the macroline hosing from your Inline
Regulator allowing it to be unscrewed from the Front
Regulator Mount (FRM) (See Figure 2.1). Inspect the
o-ring at the top of the threads on the FRM for damage.
Replace and re-lubricate as necessary.
1
Turn the Inline Regulator upside down and carefully
unscrew the bottom section from the top section (See
Figure 2.2)
.
Remove the Inline Regulator Spring from the top
section (See Figure 2.3), then gently push the Piston out
of the Inline Regulator Top (See Figure 2.4).
Insert a 1/8” hex key into the Adjuster Screw in the
bottom section of the Inline Regulator, turn the
Adjuster Screw clockwise through the top of the Inline
Regulator Bottom (See Figure 2.5), and pull out of the
Inline Regulator Bottom when it will no longer turn
upwards (See Figure 2.6 OVerLeAF).
2
1
If any o-rings are damaged then replace them. Extra
o-rings are available in parts kits available at
www.planeteclipse.com
2
The adjuster screw can only be removed by turning
it upwards through the bottom section of the inline
regulator. The regulator will be damaged if the adjuster
screw is removed incorrectly.
WARNING: REMOVE ALL PAINTBALLS & DEGAS YOUR
MARKER, DISCHARGING ANY STORED GAS IN A SAFE
DIRECTION, DISCONNECT THE BATTERY & REMOVE THE
BARREL, LOADER & AIR SYSTEM TO MAKE THE MARKER
EASIER & SAFER TO WORK ON.
CLEANING THE SL3
INLINE REGULATOR
Fig 2.1
Fig 2.2
Fig 2.4
Fig 2.3
Fig 2.5
FEATURE SUPPLEMENT
11