User Manual

The Eclipse SLS marker comes with the new SL3
Inline Regulator. This design provides a substantial
performance increase over previous Planet Eclipse
Inline Regulators.
1,2
Adjusting the velocity of the SLS can be done by
inserting 1/8” hex key into the Adjuster Screw at
the bottom of the SL3 Inline Regulator. Turning the
Adjuster Screw clockwise will decrease the output
pressure of the regulator and consequently the
velocity. By turning the Adjuster Screw counter
clockwise you will increase the output pressure and
consequent velocity.
3,4
1
The threads on the SL3 Inline Regulator are not the standard
regulator threads found on all previous Planet Eclipse markers.
2
Both high and low pressure output preset air systems can be used
with the SL3 Inline Regulator.
3
After each adjustment re at least two clearing shots to gain an
accurate velocity reading.
4
For further information on adjusting the velocity please consult
the ‘Adjusting the Velocity’ section of the Ego10 operators
manual.
WARNING: THE SWIVEL CAN ONLY BE REMOVED
FROM THE REGULATOR BOTTOM AFTER THE
MACROLINE FITTING HAS FIRST BEEN REMOVED FROM
THE SWIVEL.
Adjuster Screw
#011 NBR 70
Purge Valve and Spring
Regulator Seal
Adjuster Top
Macroline Fitting
Inline Regulator
Spring
Inline Regulator
Piston
#016 NBR 70
Inline Regulator
Bottom
#011 NBR 70
Inline Regulator
Swivel
Inline Regulator
Top
#008 NBR 70
#016 NBR 70
SL3 INLINE REGULATOR
FEATURE SUPPLEMENT
10