Manual

The Break Beam Sensor System, referred to elsewhere in this
manual as ‘BBSS’ is used to detect when a paintball is ready
to be fired from the Ego LV1. If no paintball is ready then the
BBSS will inhibit the Ego LV1 from firing. This prevents the Ego
LV1 from “chopping” paintballs that are not fully loaded into
the marker.
1
To switch off the BBSS, press and hold the button for 0.5
seconds
(SEE FIGURE 4A)
.
The BBSS indicator on the top right
of the LCD will change from (enabled) to (disabled).
To switch the
BBSS
back on, press and hold the button
for 0.5 second. The indicator will change back to .
When the BBSS is enabled, the indicator will change
depending upon whether the system has detected a ball or
not. When no ball has been detected the indicator will look
like this . When a ball has been detected the icon changes
to look like this .
Additional features of the Ego LV1’s Break Beam Sensor
System are covered in full on page 23 of this operators
manual.
1
When the Ego LV1 is turned on, the Break Beam Sensor System is
automatically enabled.
USiNG THE BREAK BEAM
SENSOR SYSTEM
FIG 4A
USiNG THE EGO LV1 9