Manual
THE BREAK BEAM SENSOR
SYSTEM
Undo the retaining screw for the BBSS eye cover on the right
hand side of the Ego LV1 using a 5/64" (2mm) hex key
(SEE
FIGURE 15A).
Remove the eye cover to expose the back of the BBSS unit
(SEE FIGURE 15B).
Using a dry cotton bud, carefully remove any
debris, paint or moisture from the back of the sensor unit and
from inside the eye cover.
Lift the BBSS unit free from the Ego LV1 body and using
another dry cotton bud, remove any grease or debris build-up
from the front of the sensor unit
(SEE FIGURE 15C)
.
Clean the hole under the BBSS unit on the body that allows
the BBSS unit to ‘see’ into the breech. Clean the pocket the
BBSS unit sits in.
DE-GAS YOUR MARKER, DISCHARGING ANY STORED GAS IN
A SAFE DIRECTION, AND REMOVE THE BARREL, LOADER, AIR
SYSTEM AND ANY PA INTBALLS TO MAKE THE MARKER
EASIER AND SAFER TO WORK ON.
WARNING
FIG 15A
FIG 15B
FIG 15C
42 MAiNTENANCE