Manual

These parameters all relate to the control of the solenoid valve.

TiMiNG

The

DWELL

parameter sets the amount of time that the solenoid is energized and therefore the amount of gas that

is released with each shot of the Ego LV1. Setting this parameter too low will result in low velocity shots and/or

excessive shot to shot velocity fluctuations. Setting the parameter too high will simply waste gas and make the Ego

LV1 louder. The

DWELL

can be set between 0.0 and 30.0 milliseconds. The factory default setting can normally be

reduced after a few thousand shots as the Ego LV1 ‘beds-in’.

“First shot drop off” is a reduction in velocity of the first shot fired after an extended period of not firing and

is caused by the stiction between dynamic o-rings and the surfaces that they are in contact with. In order to

compensate for first shot drop-off this parameter can be set to add extra time to the

DWELL

parameter for the

first shot. This parameter can be set between 0.0 and 5.0 milliseconds.

The time that has to elapse before the FSD COMP is applied to a shot following a previous shot. This parameter

can be set between 00:00 and 04:00 minutes.

DWELL

PARAMETER

FSD COMP

PARAMETER

FSD DLY

PARAMETER

ADVANCED SETUP 33