Manual

This parameter is used to select the firing mode of the Ego LV1 and has the following choices:
> SEMI: This is the default and in this firing mode the Ego LV1 will fire one shot for every trigger pull.
> RAMP: In this firing mode, the rate of fire is increased above the rate at which the trigger is pulled once certain
criteria have been met. These criteria are set by the parameters on the
RAMP SETUP
menu.
1
> CANCEL: Editing is cancelled and the parameter is unchanged.
The
ROF CAP
parameter is used to specify whether or not the Ego LV1 should have a limited / capped rate of fire.
When the
ROF CAP
is enabled (and the BBSS is enabled), the maximum achievable rate of fire is set by the
BS ON
ROF
parameter. Choices for the
ROF CAP
parameter are:
> OFF: Rate of fire only limited by the loader.
> ON: Rate of fire limited to the
BS ON ROF
parameter value.
> CANCEL: Cancel editing and leave the parameter unchanged.
1
Some presets and fire modes may only be available in certain countries and on some models of the Ego LV1.
FiRE MODE
PARAMETER
ROF CAP
PARAMETER
The
BS ON ROF
parameter is used to set the maximum achievable rate of fire from the Ego LV1. The value of this
parameter can be adjusted between 4.0 and 30.0 balls per second in 0.1bps increments.
The
BS ON ROF
parameter will only be displayed if you have set the
ROF CAP
parameter to ‘ON’.
BS ON ROF
PARAMETER*
The
BS OFF ROF
parameter is used to control how fast the Ego LV1 cycles when the Break Beam Sensor System is
disabled. This parameter can be set between 4.0 and 15.0 balls per second and should always be set to the slowest
speed of the loading system in use.
BS OFF ROF
PARAMETER
30 ADVANCED SETUP