Manual
This parameter is used to save the current set of parameters as a user defined custom preset configuration.
This parameter has the following choices:
> USER 1: Save the current parameters as the preset ‘USER 1’.
> USER 2: Save the current parameters as the preset ‘USER 2’.
> CANCEL: Editing is cancelled and the parameter remains unchanged.
This parameter is used to load the required preset configuration and has the following choices:
> USER 1: Load a set of custom firing mode parameters that have been previously saved by the user.
> USER 2: Load a set of custom firing mode parameters that have been previously saved by the user.
> FACTORY: Reset every parameter to the factory set default. The Ego LV1 leaves the factory set in this way.
> NPPL: Load a
set of parameters that configures the Ego LV1 to comply with the NPPL rules governing firing modes.
1,2
> PSP 10: Load a set of
parameters that configures the Ego LV1 to comply with the PSP rules governing firing modes in lower
divisions (10bps).
1,2
> PSP 12: Lo
ad a set of parameters that configures the Ego LV1 to comply with the PSP rules governing firing modes in higher divisions
(12bps).
1,2
> MS10: Load a
set of parameters that configures the Ego LV1 to comply with the 2010 Millennium Series rules governing firing modes.
1,2
> CANCEL: Editing is cancelled and the parameter remains unchanged.
In order to simplify the set up of the Ego LV1 a number of preset configurations are available for selection.
Choosing one of these presets will cause all of the necessary parameters to be set in such a way as to make the
Ego LV1 comply with the rules governing a particular paintball league
1
. It is also possible for the user to save up to
two preset configurations of their own.
1
Some presets and fire modes may only be available in certain countries and on some models of the Ego LV1.
2
All presets are correct at time of printing. It is the users responsibility to ensure that the loaded preset complies with the event rules the marker is intended to be
used in.
PRESET
MENU
LOAD
PARAMETER
SAVE
PARAMETER
ADVANCED SETUP 29