Manual

THE SOUND iNDiCATOR
THE TRiGGER DETECTiON iNDiCATOR
In order for the trigger to be successfully operated it must first be released and then pulled. The trigger detection indicator
(TDI) is used to indicate each of the possible trigger states.
From the factory the Ego LV1 will have the OPTO sensor enabled. The micro-switch can be enabled from the Hardware menu
(see page 37).
The sound indicator on the run screen is used to convey if the Sound parameter in the Hardware menu (page 37) is switched
on or off.
There are two possible conditions that can be indicated:
SOUND ENABLED
The SOUND parameter is enabled. The Ego LV1 will
make sounds when switched on and off and when
the game timer alarms or times out.
SOUND DISABLED
The SOUND parameter is disabled. The Ego LV1 will
not make any sounds.
MICRO-SWITCH SELECTED, NOT ACTUATED
The Ego LV1 is configured to use the
micro-switch to detect trigger pulls. The
micro-switch is not currently actuated, i.e.
the trigger is released.
MICRO-SWITCH SELECTED, ACTUATED
The Ego LV1 is configured to use the micro-switch to detect
trigger pulls. The micro-switch is currently actuated, i.e. the
trigger is pulled.
OPTO SENSOR SELECTED, READING ABOVE PULL POINT
The Ego LV1 is configured to use the OPTO sensor
to detect trigger pulls. The OPTO sensor is currently
reading above the OPTO pull point, i.e. the trigger is
considered ‘pulled’.
OPTO SENSOR SELECTED, READING 0%
The Ego LV1 is configured to use the OPTO sensor
to detect trigger pulls. The OPTO sensor is currently
reading 0%, i.e. the trigger is fully released.
OPTO SENSOR SELECTED, READING 100%
The Ego LV1 is configured to use the OPTO sensor
to detect trigger pulls. The OPTO sensor is currently
reading 100%, i.e. the trigger is fully depressed.
OPTO SENSOR SELECTED, READING BELOW RELEASE
POINT
The Ego LV1 is configured to use the OPTO sensor
to detect trigger pulls. The OPTO sensor is currently
reading below the OPTO release point, i.e. the trigger
is considered ‘released’.
OPTO SENSOR SELECTED, READING MID-RANGE
The Ego LV1 is configured to use the OPTO sensor
to detect trigger pulls. The OPTO sensor is currently
reading somewhere between the OPTO release point
and the OPTO pull point, i.e. the trigger is half
depressed.
24 USiNG THE EGO LV1