Manual

The BBSS is able to switch itself off in the event of a blockage or contamination preventing it from functioning correctly. In this
instance, the BBSS will switch itself back on once the blockage is cleared and the correct operation can be resumed.
The BBSS indicator on the main screen is used to indicate the eight possible states of the BBSS as follows:
THE BBSS iNDiCATOR
THE AUX OUT iNDiCATOR
The auxiliary socket on the Ego LV1 circuit board allows third party products such as loaders or RF transmitters to be
interfaced to the Ego LV1.
The AUX out indicator is turned on and off via the AUX OUT parameter (see page 39).
There are two possible conditions that can be indicated:
BBSS ENABLED AND BALL DETECTED
The Ego LV1 can be fired at the maximum rate of fire
determined by the chosen firing mode.
BBSS FAULT HAS BEEN CLEARED AND BALL DETECTED
The system has been re-enabled. A ball is detected
and the Ego LV1 can be fired at the maximum rate
of fire determined by the chosen firing mode.
BBSS ENABLED NO BALL DETECTED
The Ego LV1 cannot be fired.
BBSS FAULT HAS BEEN CLEARED AND NO BALL DETECTED
The system has been re-enabled. No ball is detected
so the Ego LV1 cannot be fired. To reset the BBSS
icon, use the button to switch off the BBSS and
then back on again.
BBSS DISABLED
The Ego LV1 can be fired at a maximum rate of fire
as set by the BS OFF ROF parameter (see page 30).
BBSS ENABLED IN TRAINING MODE
The BBSS has been over-ridden as the user has
selected training mode. As the user has chosen to
leave the BBSS on, the achievable rate of fire is
limited by the firing mode.
BBSS FAULT DETECTED
The system is disabled. The Ego LV1 can only be
fired at a maximum rate of 2bps less than the
maximum rate of fire, up to a maximum of 10 bps.
BBSS DISABLED IN TRAINING MODE
The BBSS has been over-ridden as the user has
selected training mode. As the user has chosen
to turn the BBSS off, the achievable rate of fire is
limited by the BS OFF ROF parameter (see page 30).
AUX OUT ENABLED
The AUX OUT is enabled. Each time the circuit board
detects a valid trigger pull a signal will be sent to
the AUX connector on the circuit board.
AUX OUT DISABLED
The AUX OUT is disabled. No signal will be sent to
the AUX connector on the circuit board.
USiNG THE EGO LV1 23