Manual

CHECK THAT THE GAS PIPE ASSEMBLY IS CORRECTLY

INSTALLED. SEE PAGE 15 FOR INSTALLATION INSTRUCTIONS

OF THE GAS PIPE.

CHECK THAT THE POPS RETAINING SCREWS ARE TIGHT. IF THE

POPS CAN BE MOVED ON THE FRAME THE SCREWS ARE TOO

LOSE. USE A 5/32” HEX KEY TO TIGHTEN THE SCREWS.

Every Ego LV1 comes complete with an Eclipse Push On Purge

System (POPS) which provides a direct connection for a preset

air system. Before screwing an air system into the POPS

ensure that the bonnet is disengaged in its forward position

(SEE FIGURE 10A)

. If the bonnet is engaged, depress the latch

button and slide the bonnet forward.

Screw the preset air system into the POPS

(SEE FIGURE 10B)

so that the bottle screws in all the way and is tight. Pull

the bonnet backwards allowing the POPS pin to depress the

pin in the preset air system causing the Ego LV1 to become

pressurised (providing that there is sufficient air in your tank)

(SEE FIGURE 10C)

. When the bonnet has been pulled back far

enough it engages with the POPS body.

1,2

You have now installed a preset air system onto your Ego

LV1.

High, mid and low pressure output preset air systems can be used with the

Ego LV1, providing the Ego LV1 has the SL4 inline regulator originally supplied

with the marker.

The force needed to engage the bonnet may vary depending on the output

pressure and internal design of the air system being used.

CONTiNUED

FIG 10A

FIG 10B

FIG 10C

USiNG THE EGO LV1 17