Manual

(CONTiNUED)
IF YOU ARE UNSURE ABOUT PERFORMING A MAINTENANCE
PROCEDURE PLEASE CONTACT YOUR NEAREST SERVICE
CENTRE.
WARNING
FIG 26F
FIG 26H
FIG 26G
FIG 26I
FIG 26J
Check the bottom face of the solenoid manifold to ensure
that it is also free from damage or debris (SEE FIGURE 26F) .
Remove, clean and inspect the solenoid rubber gasket as
shown in FIGURE 26G . Replace the gasket ensuring that it lies
flat in its designated groove in the solenoid manifold body
(SEE FIGURE 26F) .
1
Inspect and clean the solenoid valve, removing any moisture,
dirt and debris, paying particular attention to the top sealing
surface and exhaust ports (SEE FIGURE 26H) .
DO NOT ATTEMPT TO DISASSEMBLE THE SOLENOID VALVE
UNIT OR THE USER WARRANTY WILL BE VOID.
Hold the solenoid manifold onto the bottom of the Ego LV1
body taking care to line it up correctly with the screw holes in
the body and to avoid pinching the BBSS wires underneath it.
Use a 5/64” hex key to tighten the three screws that hold the
solenoid manifold onto the Ego LV1 body (SEE FIGURE 26I) .
1
DO NOT over tighten the retaining screws for the manifold or
solenoid. Doing so can crack the manifold.
Hold the solenoid valve onto the bottom face of the solenoid
manifold ensuring the small solenoid rubber gasket is still
in place, line up the two screw holes. Screw the solenoid
retaining screws into the solenoid manifold (SEE FIGURE 26J) .
2
You have now successfully stripped and cleaned your Ego LV1
solenoid assembly.
1
Replace any worn/damaged seals using authentic Eclipse Ego LV1 spare
parts.
2
DO NOT over tighten retaining screws, doing so may strip the threads
or damage the part being retained.
60 MAiNTENANCE