Manual
(CONTiNUED)
Screw the LPR adjuster out from the LPR cap using a 1/8” hex key
(SEE FIGURE 20I)
. Clean and inspect the adjuster o-ring
(LABELLED
A
FIGURE 20J)
, replacing if necessary. Lubricate the o-ring with a
small amount of grease.
Clean and inspect the LPR seal in the tip of the adjuster
(LABELLED
B
FIGURE 20J)
. If the seal is damaged or heavily worn, pull the tip
off the adjuster and replace.
Lastly clean and inspect the o-rings on the LPR cap
(SEE FIGURE
20K)
. If the large outside o-ring
A
is damaged replace, otherwise
apply a small amount of grease.
Insert the LPR adjuster into the LPR cap. Using a 1/8” hex key screw
the adjuster all the way out until the adjuster stops turning
(SEE
FIGURE 20L)
.
Screw the LPR cap with LPR adjuster onto the LPR body. Place the
spring over the LPR piston and push the piston into the LPR body
(SEE FIGURE 20M)
.
Take the complete LPR assembly and push the assembly into the LPR
bore of the LV1 body
(SEE FIGURE 20N)
.
Re-insert the valve plug with attached valve stem
(LABELLED
A
FIGURE 20O)
ensuring the valve stem captures the valve spring
(LABELLED
B
FIGURE 20O)
inside the Ego LV1 body.
Push and hold the valve plug firmly up to the LV1 body, take the
tuning fork and insert it into the FRM positioning the forks either side
of the LPR body. Push the fork up into the body until the tips of the
fork stop against the inside of the body
(SEE FIGURE 20P)
. Replace
the foregrip crown and regulator as detained on page 45.
Finally reset the LPR to the factory setting by firstly using a 1/8”
hex key to screw the adjuster clockwise until a small amount of
resistance is met and then by screw the adjuster counter-clockwise
1 full turn.
1
The internals of your LPR may vary according to the model of Ego LV1
you have.
2
The adjuster screw does not need to be removed from the LPR Cap for
regular maintenance.
IF YOU ARE UNSURE ABOUT PERFORMING A MAINTENANCE
PROCEDURE PLEASE CONTACT YOUR NEAREST SERVICE
CENTRE.
WARNING
FIG 20I
FIG 20K
FIG 20M
FIG 20O
FIG 20J
FIG 20L
FIG 20N
FIG 20P
A
A
A
B
B
MAiNTENANCE 51