Manual

1
Always calibrate your Ego LV1 ROF CAP parameters to the local field BPS meter as readings may vary from meter to meter.
This menu is only available when ramping has been selected with the FIRE MODE parameter and comprises a list of
parameters that control the way in which the Ego LV1 ramps, as shown below.
RAMP SETUP MENU
This parameter is used to select the ramping style and has the following choices:
> STEP: Step ramping will cause the Ego LV1 to shoot in semi-automatic until a number of trigger pulls, set by SEMI
SHOTS , have been made at a minimum pull rate, set by KICK IN . At this point the rate of fire will step up to the
maximum rate of fire as set by BS ON ROF (or the maximum loader speed if the ROF CAP parameter is set to off).
Ramping is maintained as long as the user continues to pull the trigger at a required rate set by SUSTAIN .
> LINEAR: Linear ramping will cause the Ego LV1 to shoot in semi-automatic until a number of trigger pulls, set by
SEMI SHOTS , have been made at a minimum pull rate, set by KICK IN . At this point the rate of fire will equal the
rate of trigger pulls increased by the percentage specified by RATE up to a maximum rate of fire as set by BS ON
ROF , if the ROF CAP is on. Ramping is maintained as long as the user continues to pull the trigger at a required
rate set by SUSTAIN .
> CANCEL: Editing is cancelled and no changes are made to the parameter.
The parameter is only available when LINEAR ramping is selected and is used to set the percentage increase in rate
of fire over rate of trigger pulls.
For example, if the user is pulling the trigger at a rate of 10 pulls per second and the RATE parameter is set to
50% then the rate of fire is 10 plus 50% extra which is 15 balls per second.
This parameter can be set between 0 and 100% in 10% increments.
TYPE PARAMETER
RATE PARAMETER*
ADVANCED SETUP 31