Manual

To access the Main menu from the run screen double-click the button and the first
item on the Main menu will be displayed. Alternatively, push and hold the button for 2
seconds.
Some of the parameters in the menu system can have a tournament lock applied to
them. This lock can be toggled on and off by pressing the tournament lock button on
the circuit board (SEE
A
IN FIGURE 14A) .
When trying to select a parameter that is locked, the a ‘LOCKED’ message will be briefly
displayed.
When the displayed item is a parameter, as indicated by a parameter value on the right of the screen, pressing the
button will activate the EDIT mode which allows the parameter value to be altered. When EDIT mode is active, the
black box surrounding the parameter name disappears. There are two types of parameter, numeric parameters and
choice parameters.
A numeric parameter has a numeric value whereas a choice parameter is one that has a small number of distinct
choices. Altering parameter values is essentially the same for both types of parameter. To alter a numeric parameter,
first activate the EDIT mode. Press the button to increase the parameter value one step at a time. Press and
hold the button to increase the parameter value rapidly. When the value reaches it’s maximum it will revert to
its minimum value. Press the button to decrease the parameter value one step at a time. Press and hold the
button to decrease the parameter value rapidly. When the value reaches its minimum it will revert to it’s maximum
value. When the required parameter value is displayed press the button to accept the value and end the EDIT mode.
To alter a choice parameter, first activate the EDIT mode. Press the button to display the next choice in the list. When the
last choice is displayed, pressing will display the first choice in the list. Press the button to display the previous choice
in the list. When the first choice is displayed, pressing the button will display the last choice in the list. When the required
choice is displayed press the button to accept the choice and end the EDIT mode. If the displayed choice is CANCEL then
pressing the button will end the EDIT mode and restore the parameter to the value that is was prior to editing.
Press and release the button to display the next item on the menu. When the last menu item is displayed, pressing the
button will display the first item.
Press and release the button to display the previous item on the menu. When the first menu item is displayed, pressing the
button will display the last item.
When the displayed item is a branch, as indicated by an animation on the right of the screen, press the button to move to
another menu.
ACCESSiNG THE MENU SYSTEM
MOViNG AROUND THE MENUS
ALTERiNG PARAMETERS
THE MARKER CAN BE FIRED WHILE NAVIGATING ALL MENUS AND PARAMETERS.
WARNING
A
FIG 14A
ADVANCED SETUP 27