Manual

Using a 5/32” hex key or your fingers, turn the sprocket
screw of the clamping feed tube counter-clockwise (SEE
FIGURE 8A).
Release the clamping lever on the feed tube (SEE FIGURE 8B)
and test to see if your loader can easily be pushed into the
top of the feed tube. If the loader cannot easily be pushed
into the feed tube, loosen the sprocket screw of the clamping
feed tube a little more by turning it counter-clockwise using a
5/32” hex key or your fingers (SEE FIGURE 8A).
When you have managed to push your loader into the
clamping feed tube, close the clamp to secure it firmly in
place (SEE FIGURE 8C). If the loader is loose then you will
need to release the clamp, tighten the sprocket screw slightly
by turning it clockwise with a 5/32” hex key or your fingers
and close the clamp. Repeat this process as necessary to
secure your loader in place.
You have now attached a loader to your Ego LV1. Once you
have filled your loader and air tank you will then be ready to
begin using your Ego LV1.
ATTACHiNG A LOADER
DO NOT OVER TIGHTEN THE CLAMPING FEED TUBE AS
THIS MAY DAMAGE THE LOADER OR FEED TUBE ITSELF.
WARNING
FIG 8A
FIG 8B
FIG 8C
14 USiNG THE EGO LV1