Manual

C
G
A
B
F
E
D
The Eclipse CSL marker comes with two
complete Trigger Systems (bearing carrier,
trigger, spring and set-screws) that are
interchangeable within the CSL frame.
For full details of how to change the Trigger
System in the CSL please consult the ‘Trigger
Assembly’ section in the ‘Ego11 Operators
Manual’. If you have any doubts about how to
conduct this procedure then do not hesitate to
contact your nearest Eclipse Service Center (see
Eclipse Certified Service Center pages of the
Ego11 Operators Manual).
For full details of how to adjust your trigger
please refer to the ‘Setting the Trigger Section’ of
the ‘Ego11 Operators Manual’.
iMPortaNt
When setting the trigger it is essential to ensure
that the electronic trigger detection is working
correctly. When the trigger is fully depressed
the Trigger Detection Indicator (TDI) should
point upwards . When the trigger is
fully released the TDI should point downwards
. For more information, see ‘The Trigger
Detection Indicator (TDI)’ and ‘Filter Menu’ in the
‘Ego11 Operators Manual’.
A Spring
B Spring Return Strength Screw
C Trigger Pin Locking Screw
D Front Stop Trigger Screw
E Magnet Return Strength Screw
F Micro Switch Activation Screw
G Rear Stop Trigger Screw
CSL triGGer SySteM
WARNING: REMOVE ALL PAINTBALLS & DE-GAS YOUR
MARKER, DISCHARGING ANY STORED GAS IN A SAFE
DIRECTION, DISCONNECT THE BATTERY & REMOVE THE
BARREL, LOADER & AIR SYSTEM TO MAKE THE MARKER EASIER &
SAFER TO WORK ON.
C
G
A
B
F
E
D
SCythe triGGer
CLaSSiC triGGer
FEATURE SUPPLEMENT
6