Fore>word From concept to creation the CSL is developed with a passion and precision rarely seen in the paintball industr y. Utilizing the latest technologies and materials it pushes the boundaries of what is possible both as a piece of design ar t and as a devastatingly effective on-field tool. Produced in limited numbers, it’s desirability and exclusivity is never in question. The CSL ; The ultimate expression of engineering and design.
WARNING: READ AND ADHERE STRICTLY TO ALL OF THE SAFETY INSTRUCTIONS AND GUIDELINES IN THE Ego11 OPERATORS MANUAL! 04 SL3 S haf t B arrel 05 CSL V alve G u ides 06 CSL Trigger 07 CSL B ol t 08 R e m oving 10 The E cli p se 11 CSL C u s t o m er Kit System System & A t t aching E - Por t al S ervice t he CSL F ra m e S of t ware & S u p p or t
SL3 shaft Barrel Kit The Eclipse CSL marker comes as standard with an Eclipse SL3 Shaft Barrel Kit.1 The bore size of the barrel back is engraved at the end of the Barrel Back C. The barrel screws into the body of the CSL using a right hand thread meaning that if you hold the CSL pointing away from you the barrel screws into the body in a counterclockwise direction.2 On the Barrel Back there are two o-rings.
CSL Valve Guides Warning: REMOVE ALL PAINTBALLS & De-gas your marker, discharging any stored gas in a safe direction, DISCONNECT THE BATTERY & remove the barrel, loader & air system to make the marker easier & SAFER to work on. Included with the Eclipse CSL marker are two Valve Guides. A LP (Low Pressure) Valve Guide which a HP (High Pressure) Valve Guide. Both of which will allow you to customize the set-up and feel of the CSL.
CSL Trigger System Classic Trigger C Warning: REMOVE ALL PAINTBALLS & De-gas your marker, discharging any stored gas in a safe direction, DISCONNECT THE BATTERY & remove the barrel, loader & air system to make the marker easier & SAFER to work on. A D E F FEATURE SUPPLEMENT The Eclipse CSL marker comes with two complete Trigger Systems (bearing carrier, trigger, spring and set-screws) that are interchangeable within the CSL frame.
CSL Bolt System Warning: REMOVE ALL PAINTBALLS & De-gas your marker, discharging any stored gas in a safe direction, DISCONNECT THE BATTERY & remove the barrel, loader & air system to make the marker easier & SAFER to work on. The Cure4 Bolt features a new cushioned bolt tip which serves the dual purpose of reducing clipping of the second ball in the stack and reducing the impact shock of the bolt face on the ball being fired.
The CSL Frame FIG 1.1 FIG 1.2 FIG 1.3 FIG 1.4 FIG 1.5 FIG 1.6 The CSL features a new body/frame interface, with a departure from the traditional front and back frame screws. The frame is now attached to the body by a single screw mounted in the back of the body. FEATURE SUPPLEMENT Removing the Frame To remove the frame from the CSL body, firstly unscrew the four grip screws using a 5/64 hex key (figure 1.1) and remove the grips entirely, exposing the CSL circuit board.
Attaching the Frame Before attaching the frame make sure the frame tag is tight in the frame, use a 1/8 hex key to tighten the retaining screw in the frame tag, see (figure 1.8). FIG 1.7 FIG 1.8 FIG 1.9 FIG 1.10 FIG 1.11 FIG 1.12 Insert the frame tag into the front of the body (figure 1.10). Now ensuring neither the wires or the hose are trapped, close the frame until the frame touches the screw mounted in the body, the rear frame screw should be visible through the hole in the frame (figures 1.11).
THE Eclipse E-Portal Warning: REMOVE ALL PAINTBALLS & De-gas your marker, discharging any stored gas in a safe direction. remove the barrel, loader & air system to make the marker easier & SAFER to work on. FEATURE SUPPLEMENT The Eclipse E-Portal allows you to connect the CSL to a PC (subject to meeting the minimum system requirements), where a number of operations can be performed: 10 Update the markers firmware - from time to time new firmware may be released by Planet Eclipse.
CSL CUSTOMER SERVICE & Support An integral part of the Eclipse CSL experience is the Customer Service and Support that you can expect to receive having successfully registered your marker for Warranty purposes. www.planeteclipse.
UK & EUROPE Call: +44 (0)161 872 5572 Unit 14 Premier Park, Acheson Way Trafford Park Road, Trafford Park, Manchester, M17 1GA, England USA & CANADA Call: 401 247 9061 Building L4 & L5, 130 Franklin Street, Warren, Rhode Island, 02 885, U.S.A Licensed under one or more of the following patents: US 6311682, 6615814, 5881707, 5967133, 6035843, 6474326B1, 6637421B2 UK GB 234270, GB 2345953 Copyright © Planet Eclipse Ltd 2011.
