User's Manual

FACTORY SET-UP GUIDE
Before using the Ego11 it is important to make
sure the Inline Regulator, Low Pressure Regulator
(LPR), both Solenoid Flow Restrictors (SFRs) and all
electronically controlled parameters are set correctly,
as all of these can have a negative effect on the
performance of the marker if incorrectly set.
The steps below will restore the Ego11 settings to the
factory settings. These settings will give the Ego11 a
more balanced performance, ideal for the average user.
-Check that the LPR is set two turns in from flush with
the LPR Cap
(SEE FIGURE 3A). See page 23 for more
information on LPR adjustment.
-Check that the both SFRs are set to the following
settings; return restrictor level 5, forward restrictor
level 7
(SEE FIGURE 3B). To access the SFRs, unscrew
and peel away the right side of the grips. See page 24
for more information on the Solenoid Flow Restrictors.
-Load the
FACTORY
preset stored on the Ego11 Circuit
Board. This preset will restore all the electronic
parameters to their default settings. See page 36 on
loading the
FACTORY
preset.
-Lastly check the Inline Regulator Adjuster Screw is
set to 4 1/2 turns clockwise from its maximum out
(counter-clockwise) position
(SEE FIGURE 3C). This will
ensure the Inline Regulator is set to an output pressure
that will not damage the Ego11 when supplied with
compressed air/nitrogen (see page 23 for more
information on the Inline Regulator).
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 3B
FIG 3C
FIG 3A
5
7
8.
QUICK SET-UP