User's Manual

USING THE BREAK BEAM
SENSOR SYSTEM
The Break Beam Sensor System, referred to elsewhere
in this manual as ‘BBSS’ is used to detect when a
paintball is ready to be fired from the Ego11. If no
paintball is ready then the BBSS will inhibit the Ego11
from firing. This prevents the Ego11 from “chopping”
paintballs that are not fully loaded into the marker.
1
To switch off the BBSS, press and hold the button
for 0.5 seconds
(SEE FIGURE 2A).
The BBSS indicator on the top right of the LCD will
change from (enabled) to (disabled).
To switch the BBSS back on, press and hold the
button for 0.5 second. The indicator will change back
to .
When the BBSS is enabled, the indicator will change
depending upon whether the system has detected
a ball or not. When no ball has been detected the
indicator looks like this when a ball has been
detected the icon changes to look like this .
Additional features of the Ego11’s Break Beam Sensor
System are covered in full on page 26 of this operators
manual.
1
When the Ego11 is turned on, the Break Beam Sensor System is
automatically enabled.
FIG 2A
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
7.
QUICK SET-UP
QUICK SET-UP
QUICK GUIDE