User's Manual

(CONTINUED)
Clean and check the condition of the single internal
005 NBR90 o-ring in the front of the POPS Insert,
replace if necessary
(SEE FIGURE 25I). Lubricate this
o-ring liberally using Eclipse Grease.
Lubricate the narrow end of the POPS Pin with a smear
of Eclipse Grease and push the Pin, narrow end first,
into the POPS Insert so that it sits in the POPS Insert
and pokes through to the front
(SEE FIGURES 25J &
25K)
.
Screw the POPS Insert back into the POPS Body
ensuring that the o-ring end goes in first
(SEE FIGURE
25G)
.
Replace the Push Rod into its designated slot
(SEE
FIGURE 25L)
, then side a 004 NBR70 O-rings on both
ends of the Push Rod. Make sure the Push Rod is
centred in the POPS Body
(SEE FIGURE 25M).
Slide the Bonnet over the POPS Body and align the hole
on the Bonnet with the front hole on the POPS Body
(SEE FIGURE 25N).
Ensure the Latch Button and Spring are attached to
each other then slide them both into the POPS Body
through the hole in the Bonnet, spring end first, making
sure the Latch Button pokes out the right side of the
Bonnet
(SEE FIGURE 25O).
Push the Button down as far as it will go, then (while still
holding down the Button) slide the Bonnet back until the
Button engages with the POPS Body and cannot slide
into the forward position
(SEE FIGURE 25P). Reconnect
the Macroline hose to the fitting on the POPS Body.
You have now successfully cleaned and maintained your
Push Operated Purge System.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
FIG 25I
FIG 25J
FIG 25K
FIG 25M
FIG 25O
FIG 25N
FIG 25P
FIG 25L
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
69.
MAINTENANCE
MAINTENANCE
QUICK GUIDE