User's Manual

THE EXHAUST VALVE
ASSEMBLY
Lift the Bolt Pin and slide the Bolt Assembly out of the
rear of the marker. Disconnect any hosing and unscrew
the Inline Regulator from the Front Regulator Mount
as detailed in the SL3 Inline Regulator section of this
maintenance guide (page 50-51). Remove the Frame
as detailed on page 58.
Take the Ego11 Body and turn it so that the underside
of the Solenoid Assembly, and Valve Plug are visible
and accessible. Using a 1/8” hex key remove the screw
from inside the Front Regulator Mount that holds the
LPR Assembly in the marker
(SEE FIGURE 24A).
Remove the entire LPR Assembly (A), Valve Spring
(B) and Exhaust Valve (C) from the marker body
(SEE
FIGURE 24B)
. Using a 1/8” hex key unscrew the Valve
Plug from the underside of the Ego11 Body
(SEE
FIGURE 24C)
. The bottom of the Valve Guide should
now be visible through the Valve Plug hole
(SEE
FIGURE 24D)
. Ensure that the Rammer is in its rear
position and taking an L-shaped hex key, place it down
through the Bolt Pin Slot in the top of the body so that
you can apply light pressure to pop the Valve Guide out
of its place in the Ego11 Body
(SEE FIGURE 24E).
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
FIG 24A
FIG 24B FIG 24C
FIG 24D FIG 24E
B
C
A
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
65.
MAINTENANCE
MAINTENANCE
QUICK GUIDE