User's Manual

(CONTINUED)
Position the Trigger so that the hole through the
Trigger lines up with the holes in the Bearing Carrier,
slide the Trigger Pin into place (
SEE FIGURE 21G).
Gently lower the Trigger Assembly and Bearing
Carrier into the Frame, taking care not to damage the
Micro-switch or the Opto sensor, and ensuring that the
Trigger is positioned correctly
(SEE FIGURE 21H).
Using a 5/64” hex key screw the right side M2.5x5
retaining screw into place but do not fully tighten it
into place
(SEE FIGURE 21I).
Ensure the Trigger moves freely within the Frame, then
using a 1/16” hex key tighten down the Trigger Pin
retaining set screw.
Place the Trigger Spring over the Bearing Carrier in its
designated groove, align the hole in the Trigger Spring
with the front/left hole in the Bearing Carrier, then
screw the retaining screw into the Frame. Tighten both
screws with a 5/64” hex key
(SEE FIGURE 21J).
DO NOT overtighten the retaining screws. Doing so
may damage the Trigger Spring and threads in the
Frame.
You have now stripped and cleaned your Ego11 Trigger
Assembly.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
FIG 21G
FIG 21H
FIG 21I
FIG 21J
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
61.
MAINTENANCE
MAINTENANCE
QUICK GUIDE