User's Manual

SWITCHING ON THE EGO11
To switch on the Ego11 press the button twice in
quick succession, referred to elsewhere in this manual
as ‘double-clicking’. The Ego11 can also be switched on
by pushing and holding the button
(FIGURE 1A).
1
SWITCHING OFF THE EGO11
Press and hold the button until the display shows
“TURN OFF”. Release the button and re-press it
to turn off the Ego11. Alternatively double click the
button to enter the menu tree then press to turn off
the Ego11.
1
FIRING THE EGO11
Pull the Trigger to fire the Ego11. The entire firing
sequence is controlled electronically by the Ego11
Circuit Board, enabling any user to easily achieve high
rates of fire.
THE EGO11 CIRCUIT BOARD
There are four sockets on the Ego11 Circuit Board; the
BBSS socket
(A) , the Ego11 Solenoid socket (B) , the
Auxiliary socket to which third party products such as
loaders and RF transmitters can be connected using
the relevant wiring harness
(C) and the Expansion
Board socket which connects the Eclipse E-Portal USB
Daughter Board to the Ego11
(D) (SEE FIGURE 1B).
2,3
1
The double clicking feature is user selectable, factory default is set
to on. It can be turned off using the Double Click parameter in the
Hardware Menu (see page 45).
2
The Auxiliary socket is turned on and off manually via the AUX OUT
parameter in the Hardware menu on page 45.
3
Eclipse E-Portal sold separately (see page 79).
FIG 1B
C
A
D
B
FIG 1A
6.
QUICK SET-UP