User's Manual

ATTACHING THE FRAME
Carefully thread the Solenoid and BBSS wires through
the access holes in the top of the Ego11 Frame
(SEE
FIGURE 20F)
. Making sure that the BBSS and Solenoid
wires are not trapped between the Frame and Body, re-
attach the Frame to the Ego11 Body by tightening the
two frame screws using a 1/8” hex key
(SEE FIGURES
20G & 20H)
.
Ensure that the BBSS cables lie neatly in the slots
provided for them in the Frame and re-connect the
Solenoid and the BBSS using relevant sockets on the
Ego11 Circuit Board
(SEE FIGURE 20I).
Adjust both the Solenoid and BBSS wires so that they
sit neatly within the Frame, making sure the wires do
not interfere with the Opto sensors or Micro-switch
(SEE FIGURE 20J).
Re-attach the Ego11 Rubber Grips to the Frame by
using a 5/64” hex key to replace the four grip screws.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 20F
FIG 20H
FIG 20I
FIG 20J
FIG 20G
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
59.
MAINTENANCE
MAINTENANCE
QUICK GUIDE