User's Manual

THE LOW PRESSURE

REGULATOR (LPR)

The Inline Regulator can be removed if needs be.

Unscrew the LPR Cap from the marker body

SEE FIGURE 18A.

Remove the LPR Piston and Rear Spring from the LPR

Cap

SEE FIGURE 18B.

Cupping the palm of one hand, turn the LPR Cap

upside down and tip the Front Spring out into your

palm

SEE FIGURE 18C.

Remove the Rear Spring from the LPR Piston and

using a dry cotton bud, carefully clean the 013 NBR70

o-ring on the LPR Piston

SEE FIGURE 18D. If the seal

is damaged then replace it. Once the seal has been

cleaned, lubricate with a light application of Eclipse

Grease so that it is ready for re-assembly.

The internals of your LPR may vary according to the model of Ego11

you have.

The adjuster screw does not need to be removed from the LPR Cap

for regular maintenance.

DE-GAS YOUR MARKER, DISCHARGING ANY

STORED GAS IN A SAFE DIRECTION, AND REMOVE

THE BARREL, LOADER, AIR SYSTEM AND ANY

PAINTBALLS TO MAKE THE MARKER EASIER AND

SAFER TO WORK ON.

FIG 18A

FIG 18B

FIG 18D

FIG 18C

54.

MAINTENANCE