User's Manual

(CONTINUED)

Remove the Rubber Detent and using a dry cotton

bud clean the Detent and it’s location point in the

Ego11 Body.

SEE FIGURE 14D). Inspect the Detent for

damage and replace if necessary.

Insert the Detent back into the Ego11 Body (SEE

FIGURE 14E)

and place the BBSS back into the

designated slot in the body

(SEE FIGURE 14B). Ensure

that the sensor unit is face down in the body i.e.

looking into the breech.

Replace the BBSS cover, then using a 5/64" hex key

screw the sensor cover retaining screw into the body

(SEE FIGURE 14F.

Repeat the procedure for the opposite side of the

Ego11.

You have now cleaned your Break Beam Sensor

System.

Replace any worn/damaged parts using authentic Eclipse Ego11

spare parts.

Ensure that the receiver sensor (indicated by red heat shrink) is

located on the right-hand side of the marker body.

IF YOU ARE AT ALL UNSURE OF PERFORMING A

MAINTENANCE PROCEDURE PLEASE CONTACT

YOUR NEAREST SERVICE CENTRE.

FIG 14D

FIG 14E

FIG 14F

ORIENTATION

USING THE EGO11

ADVANCED SET-UP

MENU TREE

MAINTENANCE

FAULT FINDING

SERVICE CENTRES

PARTS LIST

SPARES & ACCESSORIES

ECLIPSE E-PORTAL

INDEX

QUICK SET-UP

CONTENTS

49.

MAINTENANCE

QUICK GUIDE