User's Manual

THE BREAK BEAM SENSOR
SYSTEM (BBSS)
Undo the retaining screw for the BBSS Cover on the
left hand side of the Ego11 using a 5/64" (2mm) hex
key
(SEE FIGURE 14A).
Remove the cover to expose the back of the sensor unit
(SEE FIGURE 14B). Using a dry cotton bud, carefully
remove any debris, paint or moisture from the back of
the sensor unit and from inside the BBSS cover.
Lift the sensor unit free from the Ego11 Body and
using another dry cotton bud, remove any grease or
debris build-up from the front face of the sensor
(SEE
FIGURE 14C)
.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 14A
FIG 14B
FIG 14C
48.
MAINTENANCE