User's Manual

SUSTAIN
THE SUSTAIN RATE PARAMETER
Once the Ego11 is ramping the user
has to continue to pull the Trigger at
a minimum rate in order to maintain
the ramping. This parameter sets this
rate and can be between 3.3 and 10.0
pulls per second in 0.1 pulls per second
increments.
RESTART
THE RAMP RESTART PARAMETER
The RESTART parameter defines the
amount of time after the last trigger
pull during which the ramp can be
restarted with a single trigger pull. If a
trigger pull occurs after the RESTART
time has expired, then the other ramp
start conditions have to be met before
ramping will restart. This parameter can
be set between 0.0 and 1.0 seconds in
0.1 second increments.
TIMING
THE TIMING MENU
These parameters all relate to the control of the
Solenoid Valve.
DWELL
THE DWELL PARAMETER
The DWELL parameter sets the amount
of time that the Solenoid is energized
and therefore the amount of gas that is
released with each shot of the Ego11.
Setting this parameter too low will result
in low velocity shots and/or excessive
shot to shot velocity fluctuations. Setting
the parameter too high will simply waste
gas and make the Ego11 louder. The
DWELL can be set between 0.0 and 25.0 milliseconds.
The factory default setting can normally be reduced
after a few thousand shots as the Ego11 ‘beds-in’.
FSD COMP
THE FIRST SHOT DROP-OFF
COMPENSATION PARAMETER
“First shot drop off” is a reduction in
velocity of the first shot fired after an
extended period of not firing and is
caused by the stiction between dynamic
o-rings and the surfaces that they are in
contact with. In order to compensate for
first shot drop-off this parameter can
be set to add extra time to the DWELL
parameter for the first shot. This parameter can be set
between 0.0 and 5.0 milliseconds.
40.
ADVANCED SET-UP