User's Manual

RAMP SETUP
THE RAMP SETTINGS MENU
This menu is only available when ramping has been
selected with the FIRE MODE parameter and comprises
a list of parameters that control the way in which the
Ego11 ramps, as shown below.
TYPE
THE RAMP TYPE PARAMETER
This parameter is used to select the
ramping style and has the following
choices:
> STEP:
Step ramping will cause the
Ego11 to shoot in semi-automatic until
a number of trigger pulls, set by SEMI
SHOTS, have been made at a minimum
pull rate, set by KICK IN. At this point
the rate of fire will step up to the maximum rate of fire
as set by BS ON ROF (or the maximum loader speed
if the ROF CAP parameter is set to off).Ramping is
maintained as long as the user continues to pull the
Trigger at a required rate set by SUSTAIN.
> LINEAR:
Linear ramping will cause the Ego11 to
shoot in semi-automatic until a number of trigger
pulls, set by SEMI SHOTS, have been made at a
minimum pull rate, set by KICK IN. At this point the
rate of fire will equal the rate of trigger pulls increased
by the percentage specified by RATE up to a maximum
rate of fire as set by BS ON ROF, if the ROF CAP is on.
Ramping is maintained as long as the user continues
to pull the Trigger at a required rate set by SUSTAIN.
> CANCEL: Editing is cancelled and no changes are
made to the parameter.
RATE
THE LINEAR RAMP RATE PARAMETER
The parameter is only available when
LINEAR ramping is selected and is used
to set the percentage increase in rate of
fire over rate of trigger pulls.
For example, if the user is pulling the
Trigger at a rate of 10 pulls per second
and the RATE parameter is set to 50%
then the rate of fire is 10 plus 50% extra
which is 15 balls per second.
This parameter can be set between 0 and 100% in
10% increments.
SEMI SHOTS
THE SEMI SHOTS MENU
The parameter sets the number of shots
in semi-automatic that are required at
the KICK IN rate before ramping will
start. The parameter can be set between
3 and 9 pulls in 1 pull increments.
KICK IN
THE KICK-IN PARAMETER
This parameter sets the minimum rate at
which the user has to pull the Trigger in
order to start ramping. This parameter
can be set between 3.3 and 10.0 pulls
per second in 0.1 pulls per second
increments.
(CONTINUED OVERLEAF)
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
39.
ADVANCED SET-UP
ADVANCED SET-UP
QUICK GUIDE