User's Manual

T-SLOT MOUNTING SYSTEM
The Ego11 utilises a T-slot arrangement to mount the
POPS to the bottom of the Frame
(SEE (A) FIGURE
8A)
. The T-slot is an improvement over the dovetail
mounting system found on most paintball markers,
and is much more able to withstand the rigours of
modern tournament paintball.
STRAIGHT HOSE FITTINGS
The straight hose fittings found on the Ego11 DO NOT
require ‘Loctite’ to secure them on the marker. These
are secured by the capture o-ring on the end of the
fitting. Only use a 3/32” hex key in the designated hole
inside the fitting to remove or re-attach the fitting
(SEE
FIGURE 8B)
. When re-attaching the fittings DO NOT
apply too much force or the threads on the fitting/
receiving part may be damaged (remember to stop
when you meet resistance).
MACROLINE HOSING
To aid the longevity of your Macroline hosing, it is
very important to remove it from (and install it back
into) the fittings in the correct manner:
Pull back the collet section of the hose fitting and keep
the collet depressed. Pull the Macroline hose out of
the hose fitting and release the collet.
Before installing the Macroline hose into the hose
fitting ensure that the end has been trimmed correctly
to ensure a tight fit in the hose fitting.
IF YOU EVER REMOVE THE MACROLINE
HOSE FROM THE FITTING, ALWAYS CHECK THE
CONDITION OF YOUR MACROLINE HOSING AND IF
IT IS WORN OR THE WRONG LENGTH REPLACE IT
IMMEDIATELY.
FIG 8A
FIG 8B
FIG 8C FIG 8D
A
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
19.
USING THE EGO11
USING THE EGO11
QUICK GUIDE