User's Manual

ECLIPSE SHAFT4 BARREL
A
B
D
C
E
The Eclipse Ego11 comes as standard with an Eclipse Shaft 4 Barrel.
1,4
The Barrel screws into the body of the Ego11 using a right hand thread meaning
that if you hold the Ego11 pointing away from you the Barrel screws into the body in a
counter-clockwise direction.
2
The Barrel comprises of two parts, a Barrel Back (A) and a Barrel Front (B) . The two
parts are joined together with a
left hand thread meaning that if you hold the barrel,
with the back nearest you, the front unscrews in a counter-clockwise direction. The bore
size of the Barrel Back is engraved at the end of the Barrel Back
(C) .
3
On the Barrel Back there is a 016 NBR 70 o-ring
(D) which prevents the barrel from
vibrating loose from the Ego11 Body when the marker is fired. There is also a 015 NBR
70 o-ring on the tip of the Barrel Back
(E) helps with alignment when the two sections
are screwed together.
Replace and lubricate these o-rings with Eclipse Grease as necessary.
1
The bore size of your Shaft4 may vary according to the
model of Ego11 you have.
2
The Ego11 will only accept COCKER threaded barrels.
Do not use any other type of barrel thread.
3
The Eclipse Shaft4 front and back barrel sections are not
interchangeable with older version Shaft front and back
barrel sections (including Shaft3 Barrel Kits).
4
The model of barrel accompanying your Ego11 may
differ from that stated in this manual.
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
11.
ORIENTATION
ORIENTATION
QUICK GUIDE