Manual

THE PUSH OPERATED PURGE
SYSTEM (POPS)
Having disconnected the Macroline hose from the
fitting on the POPS Body, fully depress the Latch
Button then slide the Bonnet forward while continuing
to depress Latch Button
(SEE FIGURE 25A).
When the Bonnet is in the forward position
(SEE
FIGURE 25B)
remove the Latch Button and Spring from
the Bonnet
(SEE FIGURE 25C) then slide the Bonnet off
the POPS Body
(SEE FIGURE 25D). Be careful not to
lose the spring.
Carefully slide the Push Rod out from either side of the
POPS Body, taking care not to lose the two o-rings on
the Push Rod
(SEE FIGURE 25E).
Clean off any dirt, debris or moisture from the Bonnet,
the POPS Body and the Latch Button
(SEE FIGURE
25F)
.
Remove the POPS Insert Assembly using a 5/32” hex
key
(SEE FIGURE 25G). Remove the POPS Pin from the
POPS Insert.
Clean and check the condition of the 007 NBR70
o-ring on the outside of the POPS Insert, replacing as
necessary
(SEE FIGURE 25H).
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 25A
FIG 25B
FIG 25C
FIG 25D
FIG 25E
FIG 25G
FIG 25F
FIG 25H
68.
MAINTENANCE