Manual

THE TRIGGER ASSEMBLY
Having removed the Frame completely from the Ego11
Body (see page 58). Unscrew the two M2.5x5 retaining
screws which hold the Bearing Carrier in the Frame.
(SEE FIGURE 21A).
Gently lift the Bearing Carrier and Trigger Assembly
free from the Frame taking care not to damage the
Micro-switch or the Opto sensors
SEE FIGURE 21B).
Remove the Trigger Spring from the Bearing Carrier,
removing any paint or moisture
(SEE FIGURE 21C).
Using a 1/16” hex key, loosen the Trigger Pin retaining
set screw from the back of the Trigger
(SEE FIGURE
21D)
.
Use a small hex key to push the Trigger Pin out of
the Bearing Carrier from one side
(SEE FIGURE 21E),
then remove the Bearing Carrier from the Trigger
(SEE
FIGURE 21F)
.
Clean the Trigger and Bearing Carrier thoroughly and
also clean the space within the Frame that the Trigger
sits in.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 21F
FIG 21C
FIG 21A
FIG 21E
FIG 21B
FIG 21D
60.
MAINTENANCE