Manual

(CONTINUED)
Lubricate all of the seals on the Rammer Shaft and
inside the Zick2 Rammer Cap and replace the Zick2
Rammer into the rear of the Ego11 Body as shown in
SEE FIGURE 19G.
1,2
Replace the Zick2 Rammer Cap, using the 3/16" hex
key to secure it into the Ego11 Body
SEE FIGURE 19H.
3
Noting the position of the Rammer Shaft in the Ego11
Body
SEE FIGURE 19I, replace the Bolt and locate the
Bolt Pin into the designated slot in the Rammer Shaft
using the dot on the Bolt as a reference guide
SEE
FIGURE 19J
.
Incorrect location of the Bolt can seriously damage
the Body of your Ego11.
1
DO NOT use Eclipse Grease on the Rammer. Only use light
paintgun oil, we recommend Eclipse Oil.
2
The number of o-rings on the Rammer may vary according to the
model of Ego11 that you have.
3
DO NOT over tighten the Rammer Cap.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
FIG 19F
FIG 19G FIG 19H
FIG 19I
DOT
SLOT
FIG 19J
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
57.
MAINTENANCE
MAINTENANCE
QUICK GUIDE