Manual

THE ZICK2 RAMMER
Pull the Bolt Pin upwards so that it disengages the
Zick2 Rammer, allowing the Bolt to be removed via the
rear of the Ego11
SEE FIGURE 19A.
Using a 3/16" hex key, unscrew and remove the Zick2
Rammer Cap at the rear of the Ego11
SEE FIGURE 19B.
Raise the front of the Ego11 and tap the Ego11 onto
your hand until the Zick2 Rammer falls into the palm
of your hand
SEE FIGURE 19C.
Thoroughly clean the Rammer Shaft and all of its
seals, paying special attention to the 009 NBR70
o-ring on the middle of the shaft
SEE FIGURE 19D),
the rear 011 NBR70 o-ring
SEE FIGURE 19E and the
condition of the Rammer Bumper Cushion inside the
Zick2 Rammer Cap
SEE FIGURE 19F OVERLEAF.
1
1
Replace any worn seals/bumpers using authentic Eclipse Ego11
spare parts.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 19A
FIG 19B
FIG 19D
FIG 19C
FIG 19E
56.
MAINTENANCE