Manual

SOLENOID
THE SOLENOID POWER PARAMETER
This parameter controls the amount of
power used by the Solenoid Valve and
should normally be left at it’s default
‘Normal’ power setting. Cold weather
(sub 0°
C
) will cause lubricants to thicken
and increase stiction in the marker
system which may cause velocity drop-
off and/or shot to shot inconsistency.
Increasing the solenoid power will often
help to eliminate these problems, but will cause more
drain on the battery. The choices available for the
parameter are:-
> NORMAL: Normal power Solenoid drive
> HI POWER: High power Solenoid drive
> CANCEL: Cancel editing and leave the parameter
unchanged
SOUND
THE SOUND PARAMETER
The Ego11 board is capable of emitting a
variety of sounds to audibly signal when
certain functions have been performed,
including, but not limited to, powering up,
powering off, changing the BBSS mode
and resetting various counters and timers.
This parameter determines if this feature
is switched on or off, switching it on will
cause increased drain on the battery. The
choices available for this parameter are:
>OFF: Sounds switched off.
>ON: Sounds switched on.
>CANCEL: Cancel editing and leave the parameter
unchanged.
TONES
THE TONES PARAMETER
This parameter determines if the Ego11
emits a tone each time any of the
Pushbuttons on the Navigation Console
are activated. As part of the smart menu
system the TONES parameter will only
be shown in the HARDWARE menu if the
SOUND parameter is switched ‘ON’. The
choices available for this parameter are:
>OFF: Tones switched off.
>ON: Tones switched on.
>CANCEL:
Cancel editing and leave the parameter
BACKLIGHT
THE LCD BACKLIGHT TIME PARAMETER
The time the LCD backlight remains
on after a Pushbutton is pushed. The
parameter can be set between 0 and 20
seconds.
If the time is set to 00:00 then the light
will not be displayed.
RED LEVEL
THE LCD BACKLIGHT RED LEVEL
PARAMETER
The percentage of red light emitted from
the LCD backlight.
44.
ADVANCED SET-UP