Manual

THE SOUND INDICATOR
The Sound indicator on the Run Screen is used to
convey if the SOUND parameter in the HARDWARE
menu (page 44) is switched on or off.
There are two possible conditions that can be
indicated:
In order for the Trigger to be successfully operated
it must first be released and then pulled. The Trigger
Detection Indicator (TDI) is used to indicate each of
the possible trigger states.
From the factory the Ego11 will have the Opto sensor
enabled. The Micro-switch option can be selected by
referring to the HARDWARE menu (see page 43).
THE TRIGGER DETECTION
INDICATOR (TDI)
SOUND ENABLED
The SOUND parameter is enabled. The
Ego11 will make sounds when switched on
and off and when the Game Timer alarms
or times out.
SOUND DISABLED
The SOUND parameter is disabled. The
Ego11 will not make any sounds.
MICRO-SWITCH SELECTED, NOT ACTUATED
The Ego11 is configured to use the micro-
switch to detect trigger pulls. The micro-
switch is not currently actuated, i.e. the
Trigger is released.
MICRO-SWITCH SELECTED, ACTUATED
The Ego11 is configured to use the micro-
switch to detect trigger pulls. The micro-
switch is currently actuated, i.e. the Trigger
is pulled.
OPTO SENSOR SELECTED, READING ABOVE
PULL POINT
The Ego11 is configured to use the Opto
sensor to detect trigger pulls. The Opto
sensor is currently reading above the Opto
pull point, i.e. the Trigger is considered
‘pulled’.
OPTO SENSOR SELECTED, READING 0%
The Ego11 is configured to use the Opto
sensor to detect trigger pulls. The Opto
sensor is currently reading 0%, i.e. the
Trigger is fully released.
OPTO SENSOR SELECTED, READING 100%
The Ego11 is configured to use the Opto
sensor to detect trigger pulls. The Opto
sensor is currently reading 100%, i.e. the
Trigger is fully depressed.
OPTO SENSOR SELECTED, READING BELOW
RELEASE POINT
The Ego11 is configured to use the Opto
sensor to detect trigger pulls. The Opto
sensor is currently reading below the
Opto release point, i.e. the Trigger is
considered ‘released’.
OPTO SENSOR SELECTED, READING
MID-RANGE
The Ego11 is configured to use the Opto
sensor to detect trigger pulls. The Opto
sensor is currently reading somewhere
between the Opto release point and the
Opto pull point, i.e. the Trigger is half
depressed.
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
27.
USING THE EGO11
USING THE EGO11
QUICK GUIDE