Manual

ADJUSTING THE VELOCITY
When using your Ego11, you may wish to change the
velocity at which your Ego11 is firing. This is done by
inserting a 1/8" hex key into the Adjuster Screw at the
bottom of your Ego11 Inline Regulator and adjusting it
accordingly
(SEE FIGURE 11A). By turning this Adjuster
Screw clockwise you decrease the output pressure of
the Inline Regulator and consequently the velocity;
by turning the Adjuster Screw counter clockwise you
increase the output pressure of the Inline Regulator
and consequently the velocity. On the bottom of the
Inline Regulator there are engraved arrows to illustrate
which direction to turn the hex key to make the
relevant adjustment.
1,2
ADJUSTING THE LPR
PRESSURE
When using your Ego11, you may wish to change the
output pressure of your LPR. This is easily done by
inserting a 1/8” inch hex key into the Adjuster Screw
at the front and adjusting it accordingly
SEE FIGURE
11B
. However we recommend that the LPR Adjuster
Screw be left set 2 turns in (clockwise) from the screw
being flush with the front of the LPR Cap.
By turning the Adjuster Screw clockwise, you decrease
the output pressure of your LPR and consequently
reduce the pressure driving your Rammer back and
forth. By turning the Adjuster Screw counter clockwise,
you increase the output pressure of your LPR and
consequently increase the pressure driving your
Rammer back and forth.
3
1
After each adjustment fire two clearing shots to gain an accurate
velocity reading. Never exceed 300fps.
2
High, mid and low pressure output preset air systems can be used
with the Ego11, providing the Ego11 has the SL3 Inline Regulator
originally supplied with the marker.
3
Turning the LPR adjuster screw in too far will prevent the Ego11
from firing.
FIG 11B
FIG 11A
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
23.
USING THE EGO11
USING THE EGO11
QUICK GUIDE