Manual

(CONTINUED)
The Micro-switch Activation Screw is used to adjust
the point in the trigger pull at which the Micro-switch
is activated. Turn the screw clockwise to decrease the
amount of Trigger travel to the activation point. Turn
the screw counter clockwise to increase the amount of
Trigger travel to the activation point
(SEE FIGURE 10D).
The Spring Return Strength Screw is used to adjust
the spring strength that returns the Trigger to its
resting position. Turn the screw clockwise to increase
the amount of spring return strength in the trigger
pull. Turn this screw counter clockwise to reduce the
amount of spring return strength in the trigger pull.
Do not turn the screw too far counter clockwise or
there will not be enough force to return the Trigger
consistently
(SEE FIGURE 10E).
When setting the Trigger it is important to ensure that
the electronic trigger detection is working correctly.
When the Trigger is fully depressed the Trigger
Detection Indicator (TDI) should point upwards
When the Trigger is fully released the TDI should point
downwards .
For more information, see understanding the Trigger
Detection Indicator (TDI) on page 27 and The FILTER
menu on pages 41-43.
FIGURE 10F KEY
Spring
Spring Return Strength Screw
Trigger Pin Retaining Screw
Front Stop Trigger Screw
Magnet Return Strength Screw
Micro Switch Activation Screw
Rear Stop Trigger Screw
B
A
C
D
E
F
G
FIG 10D
FIG 10E
FIG 10F
C
D
E
F
G
B
A
22.
USING THE EGO11