Manual

SETTING THE TRIGGER
The Ego11 provides the user with the option to use
either a Micro-switch or an Opto sensor as the means for
detecting trigger pulls. Before you begin to adjust and set
your Trigger, you must first select the method of trigger
detection that you wish to use by entering the Main Menu
and making your selection from the HARDWARE menu (see
page 43).
There are five adjustment points on the Trigger – the Front
Stop Trigger Screw, the Rear Stop Trigger Screw, the
Magnet Return Strength Screw, the Micro Switch Activation
Screw and the Spring Return Strength Screw.
As standard each Ego11 comes with a factory set trigger
travel of approximately 2mm in total length; one millimeter
of travel before the firing point and one millimeter of travel
after the firing point, and the trigger detection method set
to Opto.
The Front Stop Trigger Screw is used to set the amount
of Trigger travel prior to the marker firing. Turn this screw
clockwise to reduce the amount of travel. Do not turn the
screw too far or the Trigger will be pushed past the firing
point and the marker will not work. Turn this screw counter
clockwise to increase the amount of Trigger travel
(SEE
FIGURE 10A)
.
The Rear Stop Trigger Screw is used to set the amount of
travel after the marker has fired. Turn this screw clockwise
to reduce the amount of travel. Do not turn the screw too
far or the Trigger will be prevented from reaching its firing
point and the marker will not work. Turn this screw counter
clockwise to increase the amount of travel
(SEE FIGURE
10B)
.
The Magnet Return Strength Screw is used to adjust the
amount of force with which the Trigger is returned to its
rest position by the magnet. Turn the screw clockwise to
increase the amount of force. Do not turn the screw too
far or it will negate the position of the Front Stop Trigger
Screw. Turn the screw counter clockwise to reduce the
amount of force. Do not turn the screw too far or there may
not be enough force to return the Trigger
(SEE FIGURE 10C).
FIG 10A
FIG 10B
FIG 10C
ORIENTATION
USING THE EGO11
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
ECLIPSE E-PORTAL
INDEX
QUICK SET-UP
CONTENTS
21.
USING THE EGO11
USING THE EGO11
QUICK GUIDE