Manual

ATTACHING A LOADER
Using a 5/32” hex key or your fingers, turn the
Sprocket Screw of the Clamping Feed Neck counter
clockwise
(SEE FIGURE 9A).
Release the Clamping Lever on the Feed Neck
(SEE
FIGURE 9B)
and test to see if your loader can easily
be pushed into the top of the Feed Neck. If the loader
cannot easily be pushed into the Feed Neck, loosen
the Sprocket Screw of the Clamping Feed Neck a little
more by turning it counter clockwise using a 5/32” hex
key or your fingers
(SEE FIGURE 9A).
When you have managed to push your loader into the
Clamping Feed Neck, close the clamp to secure it
firmly in place
(SEE FIGURE 9C). If the loader is loose
then you will need to release the clamp, tighten the
Sprocket Screw slightly by turning it clockwise with
a 5/32” hex key or your fingers and close the clamp.
Repeat this process as necessary to secure your loader
in place.
You have now attached a loader to your Ego11. Once
you have filled your loader and air tank you will then be
ready to begin using your Ego11.
DO NOT OVER TIGHTEN THE CLAMPING FEED
NECK AS THIS MAY DAMAGE THE LOADER OR FEED
NECK ITSELF.
FIG 9A
FIG 9B
FIG 9C
20.
USING THE EGO11