User's Manual
REMOVING THE FRAME
Disconnect any hosing and unscrew the inline regulator
from the front regulator mount as detailed in the Cleaning
the Inline Regulator section of this maintenance guide
(pages 50-51).
Using a 5/64” hex key remove the six screws that attach the
Ego10 rubber grips to the Ego10 grip frame SEE FIGURE
14.1
. Unplug the solenoid and unplug the break beam
sensor system from their connections on the Ego10 circuit
board SEE FIGURE 14.2.
Using a 1/8” hex key undo the two frame retaining screws
SEE FIGURE 14.3 and remove the frame from the Ego10
body, taking care not to damage any wires SEE FIGURE
14.4
.
You have now removed the frame.
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS
TO MAKE THE MARKER EASIER AND SAFER TO WORK
ON.
WARNING
FIG 13.7
FIG 14.3
FIG 14.4
FIG 14.2
FIG 14.1
WARNING: IF YOU ARE AT ALL UNSURE OF PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES
7273
WARNING
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO10
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
57.
MAINTENANCE
MAINTENANCE
QUICK GUIDE