User's Manual

CONTINUED

Lubricate all of the seals on the rammer shaft and inside

the rammer cap and replace the rammer into the rear of

the Ego10 body as shown in SEE FIGURE 12.7.

Replace the rammer cap, using the 3/16" hex key to secure

it into the Ego10 body SEE FIGURE 12.8.

Noting the position of the rammer in the Ego10 body SEE

FIGURE 12.9,

replace the bolt and locate the bolt pin into

the designated groove in the rammer shaft using the dot

on the bolt as a reference guide SEE FIGURE 12.10.

FIG 12.7

FIG 12.8

FIG 12.10FIG 12.9

FIG 12.6

NOTE: DO NOT USE ECLIPSE GREASE ON THE RAMMER.

ONLY USE LIGHT PAINTGUN OIL, WE RECOMMEND ECLIPSE

GUN OIL.

NOTE: THE NUMBER OF ORINGS ON THE RAMMER MAY

VARY ACCORDING TO THE MODEL OF EGO10 THAT YOU

HAVE.

NOTE: DO NOT OVER TIGHTEN THE RAMMER CAP SCREW.

DOT

WARNING: IF YOU ARE AT ALL UNSURE OF PERFORMING

THE MAINTENANCE PROCEDURE PLEASE CONTACT

YOUR NEAREST ECLIPSE SERVICE CENTRE. SEE PAGES

7273

WARNING

CONTENTS

ORIENTATION

QUICK SET-UP

USING YOUR EGO10

ADVANCED SET-UP

MENU TREE

MAINTENANCE

FAULT FINDING

SERVICE CENTERS

PARTS LIST

SPARES & ACCESSORIES

INDEX

55.

MAINTENANCE

QUICK GUIDE