User's Manual

ADJUSTING THE VELOCITY

When using your Ego10, you may wish to change the

velocity at which your Ego10 is ring. This is done by

inserting a 1/8" hex key into the adjuster screw at the

bottom of your Ego10 inline regulator and adjusting it

accordingly SEE FIGURE 7.1. By turning this adjuster

screw clockwise you decrease the output pressure of the

inline regulator and consequently the velocity, by turning

the adjuster screw counter clockwise you increase the

output pressure of the inline regulator and consequently

the velocity. On the bottom of the inline regulator there are

engraved arrows to illustrate which direction to turn the

hex key to make the relevant adjustment.

ADJUSTING THE LPR

PRESSURE

When using your Ego10, you may wish to change the

output pressure of your LPR. This is easily done by inserting

a 1/8" inch hex key into the adjuster screw at the front

and adjusting it accordingly SEE FIGURE 7.2. However

we recommend that the LPR screw be left set 2 turns in

(clockwise) from the screw being ush with the front of the

LPR cap.

By turning the adjuster screw clockwise, you decrease the

output pressure of your LPR and consequently reduce the

pressure driving your rammer back and forth. By turning

the adjuster screw counter clockwise, you increase the

output pressure of your LPR and consequently increase the

pressure driving your rammer back and forth.

NOTE: AFTER EACH ADJUSTMENT FIRE TWO CLEARING

SHOTS TO GAIN AN ACCURATE VELOCITY READING. NEVER

EXCEED 300FPS.

NOTE: TURNING THE ADJUSTER SCREW IN TOO FAR WILL

PREVENT THE EGO10 FROM FIRING.

FIG 7.1

FIG 7.2

24.

USING YOUR EGO10