User's Manual
SETTING UP YOUR EGO10
Before you can begin to use your Ego10, you will need to
attach an air system and a paintball loader.
INSTALLING A PRESET AIR
SYSTEM
Every Ego10 comes complete with an Eclipse On/O
Purge System (OOPS) which provides a direct connection
for a preset air system. Before screwing the air system
into the OOPS ensure that the On/O knob is wound out
approximately half way SEE FIGURE 4.1. Be careful not to
unscrew the On/O knob too far as it will come completely
o the OOPS. If this happens, replace the On/O knob
by screwing it back onto the OOPS body in a clockwise
direction.
Screw the preset air system into the OOPS SEE FIGURE
4.2
so that the bottle screws in all the way and is tight.
Slowly turn the On/O knob in a clockwise direction
allowing the OOPS to depress the pin of the preset
air system causing the Ego10 to become pressurised,
providing that there is sucient air in your tank SEE
FIGURE 4.3.
You have now installed a preset air system onto your
Ego10.
NOTE: WE RECOMMEND USING A PRESET AIR SYSTEM
WITH A HIGH PRESSURE OUTPUT TO ACHIEVE OPTIMUM
PERFORMANCE FROM THE EGO10, HOWEVER MOST GOOD
QUALITY LOW PRESSURE OUTPUT SYSTEMS WILL ALSO
WORK ON THE EGO10.
WARNING: ALWAYS RELIEVE ALL RESIDUAL GAS
PRESSURE FROM THE EGO10 BEFORE UNSCREWING
THE PRESET AIR SYSTEM.
WARNING
WARNING: THE EGO10 CANNOT BE USED WITH CO2,
IT CAN ONLY BE POWERED BY COMPRESSED AIR OR
NITROGEN.
WARNING
FIG 4.3
FIG 4.2
FIG 4.1
WARNING: MAKE SURE THE MARKER IS TURNED OFF
AND THAT NO PAINTBALLS ARE IN THE MARKER OR
LOADER BEFORE INSTALLING AN AIR SYSTEM.
WARNING
18.
USING YOUR EGO10