User's Manual

USING THE BREAK BEAM
SENSOR SYSTEM
The break beam sensor system, referred elsewhere in this
manual as ‘BBSS’ is used to detect when a paintball is ready
to re from the Ego10. If no paintball is ready then the
BBSS will inhibit the Ego10 from ring. This prevents the
Ego10 from ‘chopping’ paintballs that are not fully loaded
into the marker.
To switch o the BBSS, press and hold the button for 0.5
seconds SEE FIGURE 3.3.
The BBSS indicator on the top right of the LCD will change
from (enabled) to (disabled).
To switch the BBSS back on, press and hold the button
for 0.5 second. The indicator will change back to .
When the BBSS is enabled, the indicator will change
depending on if the system has detected a ball or not.
When no ball has been detected the indicator looks like
this when a ball has been detected the icon changes to
look like this .
Additional features of the Ego10’s break beam sensor
system are covered in full on page 26 of this user manual.
NOTE: WHEN THE EGO10 IS TURNED ON, THE BREAK BEAM
SENSOR SYSTEM IS AUTOMATICALLY ENABLED.
FIG 3.3
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO10
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
17.
QUICK SET-UP
QUICK SET-UP
QUICK GUIDE