Manual

SYMPTOM POSSIBLE CAUSE
Although a fresh battery has been fitted, the
Ego10 will not switch on.
The battery does not seem to last very long.
The Ego10 leaks from the solenoid.
The Ego10 leaks down the barrel.
Gas vents quickly down barrel as soon as it
is gassed up.
The battery has been fitted incorrectly.
The battery terminals are not making
proper contact with the battery.
The battery type is of a low quality.
The gasket is damaged and/or not seated
correctly in its designated pocket in the
solenoid body.
Damaged Ego10 solenoid.
LPR is supercharging causing intermittent
leaking.
Solenoid Spool shaft is damaged or dirty.
Damaged or incorrect seals on rammer.
It is leaking from the barbs.
It is over-pressurizing from damaged seals
on the LPR body.
Leaky exhaust valve.
Damaged exhaust valve guide.
Incorrect seal on front of exhaust valve
guide.
The exhaust valve has become jammed in
the exhaust valve guide.
Fit the battery correctly with the positive
terminal nearest to the side of the frame.
Remove the battery, gently bend the
terminals towards where the battery will sit
and then replace the battery.
Use an alkaline or lithium battery. Do not
use a low quality or rechargeable battery.
Replace the gasket if damaged using
Ego10 parts kit. Ensure the gasket is seated
correctly.
Replace Ego10 solenoid.
Clean LPR piston seal.
Inspect regulator seal (in LPR piston) and
regulator seat (in LPR body). Replace if
necessary.
Clean or replace if required.
Replace seals.
Check hose for cuts or replace barbs.
Change LPR body seals.
Replace exhaust valve.
Replace exhaust valve guide and o-rings.
Replace front seals on exhaust valve guide
with 013 NBR70.
Replace exhaust valve and exhaust valve
guide as necessary (see Maintenance
section).
SOLUTION
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR EGO10
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTERS
PARTS LIST
SPARES & ACCESSORIES
INDEX
69.
FAULT FINDING
FAULT FINDING
QUICK GUIDE