Manual

CONTINUED

Note how one side of the exhaust valve guide is at (A)

whilst the other is raised (B) to create the surface that

the exhaust valve seals on SEE FIGURE 17.7. Inspect

the sealing face of both the exhaust valve guide and the

exhaust valve for any excessive wear or damage. If either

the exhaust valve or the exhaust valve guide are damaged

then replace with authentic Ego10 parts.

Lubricate both of the o-rings on the exhaust valve guide

with Eclipse Gun Oil SEE FIGURE 17.8. Lubricate the

o-rings on the LPR body with Eclipse Gun Oil SEE FIGURE

17.9.

Place the exhaust valve in the exhaust valve guide, making

sure that the sealing faces are next to each other, and place

the valve spring over the end of the exhaust valve and then

place this sub-assembly over the LPR body SEE FIGURE

17.10

Holding the LPR assembly so that the larger hole on the

LPR body is facing the bottom of the marker body, insert

the valve assembly, valve spring and LPR assembly into the

front of the marker body SEE FIGURE 17.11.

FIG 17.9

FIG 17.10

FIG 17.7

FIG 17.11

NOTE: MAKE SURE THE LARGER DIAMETER FRM SCREW

HOLE ON THE LPR BODY AND THE BLOCKED SIDE OF THE

EXHAUST VALVE GUIDE ARE IN LINE WITH EACH OTHER

BEFORE INSERTING THE PART STACK INTO THE EGO10.

FIG 17.8

64.

MAINTENANCE