Manual
ATTACHING THE FRAME
Carefully thread the solenoid and break beam sensor
system wires through the access holes in the top of the
Ego10 grip frame SEE FIGURE 14.5 and re-attach the grip
frame to the marker body by tightening the two grip frame
screws using a 1/8” hex key SEE FIGURE 14.6.
Ensure that the break beam sensor system cables lie neatly
in the slots provided for them in the Ego10 grip frame
and connect the solenoid and the break beam sensors
to their relevant connections on the Ego10 circuit board
SEE FIGURE 14.7. Adjust both the solenoid wires and
the break beam sensor system wires so that they sit neatly
within the grip frame SEE FIGURE 14.8.
Re-attach the Ego10 rubber grips to the frame by using a
5/64” hex key to replace the 6 grip screws.
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS
TO MAKE THE MARKER EASIER AND SAFER TO WORK
ON.
WARNING
FIG 14.6
FIG 14.7
FIG 14.8
FIG 14.5
58.
MAINTENANCE