Manual
CLEANING THE LOW
PRESSURE REGULATOR
LPR
The inline regulator can be removed if needs be.
Unscrew the LPR cap from the marker body
SEE FIGURE 11.1.
Remove the LPR piston and rear spring from the LPR cap
SEE FIGURE 11.2.
Cupping the palm of one hand, turn the LPR cap upside
down and tip the front spring out into your palm SEE
FIGURE 11.3.
Remove the rear spring from the LPR piston and using a
dry cotton bud, carefully clean the 013 NBR 70 o-ring on
the LPR piston
SEE FIGURE 11.4. If the seal is damaged
then replace it. Once the seal has been cleaned, lubricate
with a light application of Eclipse Grease so that it is ready
for re-assembly.
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS
TO MAKE THE MARKER EASIER AND SAFER TO WORK
ON.
WARNING
NOTE: THE ADJUSTER SCREW DOES NOT NEED TO
BE REMOVED FROM THE LPR CAP FOR REGULAR
MAINTENANCE.
NOTE: THE INTERNALS OF YOUR LPR MAY VARY
ACCORDING TO THE MODEL OF EGO10 YOU HAVE.
FIG 11.2
FIG 11.4
FIG 11.3
FIG 11.1
52.
MAINTENANCE